Your Rainman high pressure hose is not considered a consumable item, but they can wear on occasion. For example, the casing may wear through over time if it rubs against an edge.
Over the years, Rainman has utilised three different configurations of high pressure hose. The current configuration started in production in December 2020. The geometry of the older configurations could make it difficult to remove the hose from the pressure vessel end cap. In these situations, we recommend replacing the end cap with the current configuration when the hose requires replacement.
Use this page as a quick guide to determine which high pressure hose assembly your system uses and which part number should be used for replacement.
Part Number: RM-HP-HOSE-CAP-ASSEMBLY
This older style HP hose may be difficult to remove from the end cap. For the replacement, it is best to replace the entire end cap of the pressure vessel.
This high pressure hose kit includes a pressure vessel end cap and the current configuration utilising a swivel elbow connector for ease of future maintenance. It also includes silicone tape, plastic zip ties, and a replacement quick connect fitting.
Please contact Rainman or your local Rainman dealer to order this assembly.
This newer style HP hose configuration has a geometry that reasonably easy to remove from the end cap. For the replacement, it is not required to change the end cap of the pressure vessel.
This high pressure hose kit matches your current configuration utilising a swivel elbow connector. It also includes silicone tape, plastic zip ties, and a replacement quick connect fitting.
If you would like to contact Rainman about the control panel and compatibility with older Rainman systems, please complete a few basic details below.